Dirt Containers; Telescopic Wand; Carpet Settings; How To Transport Cleaner - Dirt Devil Featherlitea Owner's Manual

TELESCOPlC WAND:
Remove wand from cleaner by pulling out at the top (Diagram 1). Twist and pull wand apart for extra
length, as described on wand. Twist again to lock.
Diagram 1 Telescopic Wand
Remove wand from side of cleaner.
CARPET SETTINGS
IMPORTANT: Put handle in the upright position before adjusting the carpet setting.
Adjust lever on nozzle to match the surface being cleaned (Diagram 2). If cleaner is difficult to push, adjust to a higher carpet setting.
HOW TO TRANSPORT CLEANER
Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 3).
NOTE: Do not push cleaner forward while leaning on back casters. Do not pull cleaner on back casters.
Diagram 2
He~ght adjust lever.
Diagram 1 Release dirt container
Depress latch to remove dirt container.
Diagram 3
Use carrying handle on back of
cleaner to move from room to room.
Diagram 2 Remove Lid
Diagram 3 Remove and clean HEPARI- Diagram 4 Replace dirt container
Remove Id by grasping both ter. Empty dirt container.
Filter must be in d~rt container before replac-
~andles and turning.
ing dirt contamer.
CLEANING DIRT CONTAINER & HEPA FILTER:
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG BEFORE SERVICING.
For filter replacement (Part #2-JC0280-000) please call 1-800-321-1134 or visit www.dirtdevil.com to locate a dealer nearest you.
NOTE: For best performance, replace filter yearly.
EMPTY & CLEAN DlRT CONTAINER:
1. Depress latch to remove dirt container from cleaner (Diagram 1). Remove lid by grasping both handles and turning lid counter-
clockwise (Diagram 2).
2. Remove and clean filter (see instructions below). Empty dirt container (Diagram
3).
3. Use a sponge and lukewarm water to wipe dirt container clean.
4. Replace Dirt Container: Set aligning tab on bottom of dirt container into rectangular slot on the cleaner, and push to snap into place
(Diagram 4). If dirt container does not snap into place, check to make sure the lid and filter are secured properly.
CLEAN THE HEPA FILTER
located in dirt container:
1. Remove dirt container. Hold dirt container, grasp top of filter, twist and firmly pull the filter up and out.
2. *Regular Maintenance: Each time the dirt container is emptied, the filter should be cleaned. Gently tap the filter firmly against the inside
of a trash can until dirt stops falling from the filter. (Filter will be discolored after use, this will not affect the filter's performance.) Do not
brush the filter.
3. Thorough Cleaning*: If you should notice a decrease in the vacuum's power or suction, inspect the cleaner for clogs, empty the dirt cup
and remove all dust and debris from the filter. Once completely cleaned, the vacuum will immediately be ready for use.
4. Replace the HEPA Filter: Return filter to dirt container. Push filter into place to prevent dirt leakage. Return dirt cup to cleaner.
*
The cleaning instructions may vary depending on the dirt conditions. In some cases, more or less cleaning of the HEPA filter may be required.