Table of Contents
Advertisement
I
NSTALLATION
The installation must be carried out by a suitably
qualified p
version of the following.
o UK
R
egulations and Safety Standards or their European Nor
Repl
acements.
o Building Regulations (issued by the Department of the
Environment).
Building Stand
o
Department).
IEE Wiring Re
o
o Electricity At Work Regulations.
Be
for connecting the appliance, m
e
ma e
rk d on the Rating Plate corresponds w
voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 13 A double pole switched
fused spur outlet, having 3 mm contact separatio
an easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your oven is located in
its housing.
o To connect the oven power cord, loosen and remove the cover
on the terminal block, in order to gain access to the contacts
inside. Make the connection, securing the cord in place with the
cable clamp provided and then immediately close the terminal
block cover again.
If you have to change the oven power cord, the earthing
o
(yellow/green) conductor must always be 10 mm longer than th
line conductors.
o Care must be taken to ensure that the temperature of the
supply cable does not exceed 50°C.
o If the mains supply cable is damaged, then it must be replaced
by an appropriate replacement.
erson, in accordance with the current
ards (issued by the Scottish Development
gulations.
ake sure that the supply voltage
ith your mains supply
n and placed in
m
e
mains
24
Advertisement
Table of Contents
