Ac Power-Fan Module; Installing An Ac Power-Fan Module - Cisco SFS 3504 Hardware Installation Manual

AC Power-Fan Module

AC Power-Fan Module
This section describes how to install and remove the AC power-fan module and includes the following
topics:
•
•

Installing an AC Power-Fan Module

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
Warning
when servicing. Statement 1034
Caution Never place your hand inside an empty module bay or anywhere inside the Cisco SFS 3504 Server
Switch.
Unused module bays should always have an AC power-fan blanking panel over the bay to ensure proper
Caution
safety, ventilation, and cooling.
To install an AC power-fan module, perform the following steps:
Ground yourself using an approved ground wrist strap.
Step 1
Remove the blanking panel if one covers the slot.
Step 2
Remove the AC power-fan module from any packaging.
Step 3
Hold the pull handle and insert the module completely into the slot (see
Step 4
Cisco SFS 3504 Multifabric Server Switch Hardware Installation Guide
4-12
Installing an AC Power-Fan Module, page 4-12
Removing an AC Power-Fan Module, page 4-14
Chapter 4 Installing and Removing Field-Replaceable Units
Figure 4-8).
OL-14325-01