Removing An Ac Power-Fan Module; Blanking Panel For Ac Power-Fan Module Slot; Installing A Power-Fan Module Blanking Panel - Cisco SFS 3504 Hardware Installation Manual

Blanking Panel for AC Power-Fan Module Slot

Removing an AC Power-Fan Module

Caution Never place your hand inside an empty AC power-fan module bay or anywhere inside the
Cisco SFS 3504 Server Switch.
To remove the AC power-fan module, perform the following steps:
Ground yourself using an approved ground wrist strap.
Step 1
Remove the power cord from the power supply.
Step 2
Unfasten the two captive screws, using a Phillips or straight-slot screwdriver.
Step 3
Step 4 Hold the pull handle, and slide the AC power-fan module out of the chassis.
Step 5 Either replace the module immediately or secure a blanking panel to the empty bay to ensure appropriate
cooling.
Caution
Blanking Panel for AC Power-Fan Module Slot
This section describes how to install and remove an AC Power-Fan module slot blanking panel and
includes the following topics:
•
•

Installing a Power-Fan Module Blanking Panel

To install a blanking panel, perform the following steps:
Ground yourself using an approved ground wrist strap.
Step 1
Remove the blanking panel from any packaging.
Step 2
Cisco SFS 3504 Multifabric Server Switch Hardware Installation Guide
4-14
Never operate the Cisco SFS 3504 Server Switch with a vacant AC power-fan module slot.
Installing a Power-Fan Module Blanking Panel, page 4-14
Removing a Power-Fan Module Blanking Panel, page 4-16
Chapter 4 Installing and Removing Field-Replaceable Units
OL-14325-01