Installing With The Data-Connection Cables Flush-Front - Cisco SFS 3504 Hardware Installation Manual

Chapter 3 Installing the Cisco SFS 3504 Server Switch
Adjust the adjustable brackets so that the holes in the brackets align with the holes in the rack posts, and
Step 5
secure the brackets to the rack posts (see
Use four standard rack screws (two for each bracket; rack screws not included in the accessory kit) to
secure the adjustable brackets to the rack posts.
Note

Installing with the Data-Connection Cables Flush-front

To install the Cisco SFS 3504 Server Switch on a rack so that the data-connection cables are flush front
to the rack posts, perform the following steps:
Step 1 Open the bag that contains the mounting hardware.
Note
OL-14325-01
The least amount of protrusion for the adjustable brackets must be 1/2 inch beyond the inside
end of the guide rail. The adjustable bracket should always be fully supported by the guide rails.
To mount a Cisco SFS 3504 Server Switch on a rack, use eight screws and eight nuts. These must
be supplied by the customer, based upon the compatibility of the screws and nuts with the
specific rack.
Mounting the Cisco SFS 3504 Server Switch on a Rack
Figure 3-2).
Cisco SFS 3504 Multifabric Server Switch Hardware Installation Guide
3-7