Installing With The Power-Fan Modules Flush-Front - Cisco SFS 3504 Hardware Installation Manual

Chapter 3 Installing the Cisco SFS 3504 Server Switch

Installing with the Power-Fan Modules Flush-front

To install the Cisco SFS 3504 Server Switch on a rack so that the power-fan module end is flush mounted
to the front rack posts, perform the following steps:
Open the bag that contains the mounting hardware.
Step 1
Note
Step 2 Attach the two rack ear brackets to the power-fan module end of the chassis using a Phillips screwdriver and
the six M4 x 8 mm. flathead screws provided (three on each side), as shown in
of the rack ear brackets. Firmly tighten the screws on the rack ear brackets to secure them to the chassis.
Figure 3-1
1
OL-14325-01
To mount a Cisco SFS 3504 Server Switch on a rack, use eight screws and eight nuts. These
screws and nuts must be supplied by the customer, based upon compatibility of the screws and
nuts with the specific rack.
Attaching the Rack-Mounting Ear Brackets at the Power-Fan Module End
S F S 35 00
S er ie s
INP UT
FA N
OK OU TP UT
OK
FA IL
AL L FA ST
EN ER S
FU LLY EN
MU ST BE
OP ER AT GA GE D
PR IOR TO
ION OF
PO WE R
SU PP LY
100 -24 0V
1
8-4 A
!
50/ 60H z
CA UT ION
: DIS CO
NN EC T
PO WE R
BE FO RE
SE RV ICI
NG
Rack ear brackets
Mounting the Cisco SFS 3504 Server Switch on a Rack
S F S 35 00
S er ie s
INP UT
FA N
OK OU TP UT
OK
FA IL
AL L FA ST
EN ER S
FU LLY EN
MU ST BE
GA GE D
OP ER AT
ION OF PR IOR TO
PO WE R
SU PP LY
100 -24 0V
8-4 A
!
50/ 60H z
CA UT ION
: DIS CO
NN EC T
PO WE R
BE FO RE
SE RV ICI
NG
2 Guide rails (pre-installed)
Cisco SFS 3504 Multifabric Server Switch Hardware Installation Guide
Figure 3-1. Use the three holes
1
2
3-5