Table of Contents
Advertisement
IP Camera Physical Details
9
10 Ethernet 10/100 RJ45 socket
11 Microphone switch
12 Video output switch
13 Audio in
General Purpose I/O Terminal Block
Figure 1-3
Figure 1-3
1
Cisco Video Surveillance 6000P IP Camera Installation Guide
1-4
Recessed reset button
shows the pin locations and descriptions.
GPIO Terminal Block Pin Locations and Descriptions
2
3
4
5
6
7
8
Recessed button that reboots the IP camera or resets it to a
default state. You can use a pin or paper clip to depress it.
Depending on how long you depress the recessed reset button,
you can do either of the following:
Reset—Press and release the recessed reset button. Wait for
•
the IP Camera to reboot.
Restore—Press and hold the recessed reset button until the
•
status LED rapidly blinks. All settings will be restored to
factory default. Upon successful restoration, the status
LED will blink green and red during normal operation.
Accepts a standard LAN cable to connect the IP camera to a
10/100BaseT router or switch.
Switches the microphone operation between the following
options:
Internal (up)—Switches to the built-in internal microphone
•
on the IP camera
External (down)—Switches to the external Microphone In
•
connector
Switches the video output between to following standards:
NTSC 60Hz (up)—switches camera operation to the
•
National Television System Committee (NTSC) standard.
PAL 50Hz (down)—switches camera operation to the
•
Phase Alternating Line (PAL) standard.
Audio input port for the IP camera.
Pin
Description
1
Power +12V
2
Digital Output
3
Digital Input
4
Ground
5
AC 24V Input
6
AC 24V Input
7
RS-485+
8
RS-485–
Chapter 1
Overview
OL-28118-01
Advertisement
Table of Contents
