Table of Contents
Advertisement
INTERMITTENT pILOT LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. BEFORE LIGHTING, smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance
•
Do not touch any electrical switch; Do not use any
phone in your building
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire
department.
1.
STOP! Read the safety information above on this page.
2. Open bottom louver assembly, (if applicable).
3. Press the "I/O" (ON/OFF) button on the valve face to "OFF."
4. Wait five (5) minutes to clear out any gas, then smell for gas
including near the floor. If you smell gas, STOP! FOLLOW
"B" in the safety information above. If you don't smell gas, go
to the next step.
LIGHTING pROCEDURE - HANDSET METHOD
1.
Turn control arrow on valve face to "ON." Press the "I/O" but-
ton to "I." Press the "OFF" and "UP" buttons on the handset,
firmly at the same time. A long "beep" will sound, followed by
5 short "beeps." Ignitor will spark and will continue until pilot
is lit. For full Remote Control operation see Appliance Instal-
lation manual.
LIGHTING pROCEDURE - MANUAL METHOD
1. Press the "I/O" (ON/OFF) button to "I."
2.
Turn control arrow on valve face to "MAN."
3.
Using a small bladed screwdriver, press and hold button
within hold on control. Manual depress piezo igniter button to
light pilot. If pilot does not light, steps 2-3 can be immediately
repeated. If the pilot will not stay lit after several tries, follow
the instructions "To Turn Off Gas to Appliance" and call your
service technician or gas supplier.
4. When the pilot is lit and stable, turn flame height control knob
counterclockwise
To adjust flame height, turn flame height control knob.
MANUAL MODE - To turn off main burner, turn flame height control knob fully clockwise
button to "O."
HANDSET MODE - Press "OFF" button on handset. To fully shut down, press "I/O" button to "O."
Page 26
LIGHTING INSTRUCTIONS
and the main burner will ignite.
TO TURN OFF GAS TO AppLIANCE
B. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
C. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
TO IGNITE PILOT
HANDSET MODE
To Ignite Burner
75
O
F
SET
OFF
Press firmly
at same time
PILOT
ELECTRODE
THERMOCOUPLE
(LPG)
THERMOCOUPLE
(NATURAL)
CORRECT PILOT FLAME
MANUAL MODE
PIEZO
IGNITER
PRESS IN
& HOLD
PILOT
ELECTRODE
THERMOCOUPLE
(LPG)
THERMOCOUPLE
(NATURAL)
INCORRECT PILOT FLAME
. To fully shut down, press "I/O"
28040-3-0511
Hide quick links:
Advertisement
Table of Contents
