Installing & Cleaning Reusable Cloth Filter; Installing & Cleaning Foam Sleeve Filter - Vacmaster VQ407S Operator's Manual

Wet/dry vacuums 4 gallon
Table of Contents

Advertisement

3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Check the hose, attachments, and power cord to verify that they have not been damaged.
IMPORTANT!
Clean or change the reusable cloth filter regularly for best performance. ALWAYS USE
REUSABLE CLOTH FILTER FOR DRY VACUUMING. If the machine is used with out the reusable cloth
filter, the motor will burn out and the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filter included is made of high quality material designed to stop small dust particles. The filter
should be used for dry pick-up only. A dry filter is necessary to pick up dust. If the reusable cloth filter is wet,
it will clog quickly and be very difficult to clean. Handle the filter carefully when removing it for cleaning and
replacing it. Check the filters for tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a filter with holes or tears, replace it immediately.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING
THE POWER HEAD FROM CONTAINER.
INSTALLING & CLEANING REUSABLE CLOTH FILTER
Installing Reusable Cloth Filter
1. Verify that the power cord is disconnected from the outlet. fig.1
2. Remove power head and place in upside down position.
3. Slide reusable cloth filter down over the filter cage making sure the whole cage is covered. (fig. 2 & 3)
4. Replace the power head on to the container.
Removing and Cleaning Reusable Cloth Filter
1. With the removed power head in the upside down position.
2. Carefully remove the reusable cloth filter from the filter cage. (fig. 4) Clean the filter by gently tapping or
brushing dirt off. Cleaning should not be done indoors in living areas.
3. Use a mild soap and water solution to wash reusable cloth filter and rinse with clean water. (fig. 5)
4. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
INSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Remove power head and place in upside down position. Follow instructions to
10
remove reusable cloth

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents