3. Remove the oil drain plug (2) to drain the oil.
4. Reinstall the drain plug and tighten the drain plug to
specification.
Oil drain plug torque: 25 N-m (2.5 kgf-m, 18lbf-ft)
5. Fill the crankcase with the recommended grade oil
(see page 58)
and install the oil fill cap.
Oil capacity (after draining):
6. Start the engine and let it idle for 2 3 minutes.
7. Stop the engine and check that the oil level is at the
upper level mark on the oil filler cap/dipstick with the
scooter upright on firm, level ground. Make sure there
are no oil leaks.
NOTE:
Let the engine and exhaust system cool before working
in those areas.
0.9 liter (0.95 US qt, 0.8 lmp qt)
-
61
(2)