Base Settings; Dial Type; Change The Dial Mode; Change The System PN Code - VTech VT1010 User Manual

Base Settings

Dial Type ( Preset to TONE )

Change the dial mode

1. Press and / to select BS SETTINGS.
2. Press OK and / to select DIAL MODE.
3. Press OK and / to select TONE or PULSE.
4. Press OK to confirm.
Change the system PIN Code
A 4-digit system PIN code is used for changing the system settings of the base station. It is used to protect your
phone against unauthorized use. The default system PIN code is 0000.
1. Press and / to select BS SETTINGS.
2. Press OK and / to select CHANGE PIN.
3. Press OK and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
5. Press OK and enter the new system PIN.
6. Press OK and enter the new system PIN again.
7. Press OK to confirm.

Paging (Find the Handset)

You can locate the handset by pressing
produce the paging tone and "PAGING..." is displayed on the LCD. You can stop the paging by pressing
any handset or on the base again.
on the base station. All the handsets registered to the base will
www.vtech.com
• If the new
PIN entered
in Step 6 is
not matched
with the new
system PIN
entered in
Step.
•
If there is
an incoming
call during
paging, the
phone will
ring with the
incoming call
instead of
paging.
on
18