Exiting Program Mode - AMX Computer Control PC Presenter Instruction Manual

Amx corporation pc presenter computer control instruction manual

Hide thumbs Also See for Computer Control PC Presenter:

Specifications (2 pages)

Table Of Contents

Table of Contents

Programming the PC Presenter

All PC Presenter programming is retained in the PC Presenter's non-volatile memory.

It is not lost during power down or shipping.

4. Press the first transmitter button to be programmed. When the button is pressed, the button's

code number and an asterisk (*) appear at the DOS prompt. The following example shows that

the transmitter button (code number 128) was pressed.

C:\>rem (128)*

PRGM EX. 12

The asterisk after the button code number indicates that the PC Presenter is in programming

mode, waiting for keystrokes to be assigned to the selected transmitter button.

5. Type the keystrokes that are to be executed by the corresponding transmitter button. For

example, type

type them.

To cancel a keystroke entry error, press a different radio transmitter button than the one used to

initiate the current keystroke assignment. If you press a different button after keystrokes are

entered, no changes are saved. This action cancels the new keystroke assignment, and the PC

Presenter remains in program mode.

6. Press the same radio transmitter button (the button pressed in step 4 a second time. This action

displays a second asterisk ("*") immediately after the recorded keystrokes, the transmitter

button's code number, and the message

shows that the transmitter button (code number 128) was programmed with the keystrokes

"Button One"

C:\>rem (128)*Button One*(128)

C:\>rem Press transmitter button to store next radio code or

C:\>rem press any key on keyboard to exit

C:\>

C:\>rem

PRGM EX. 13

The PC Presenter remains in program mode until you tell it to exit

7. Repeat steps 4-6 to assign keystrokes to other buttons, or to change keystroke assignments for

any programmed button.