Pppoe Intermediate-Agent (Interface) - Cisco Catalyst 4500 Series Command Reference Manual

pppoe intermediate-agent (interface)

pppoe intermediate-agent (interface)
This command takes effect only if you enable the pppoe intermediate-agent global command.
Note
To enable the PPPoE Intermediate Agent feature on an interface, use the pppoe intermediate-agent
command. To disable the feature, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults Disabled on all interfaces.
Command Modes Interface configuration mode
Command History Release
12.2(50)SG
Usage Guidelines PPPoE Intermediate Agent is enabled on an interface provided the PPPoE Intermediate Agent is enabled
both on the switch and the interface.
Examples This example shows how to enable the PPPoE Intermediate Agent on an interface:
Switch(config-if)# pppoe intermediate-agent
This example shows how to disable the PPPoE Intermediate Agent on an interface:
Switch(config-if)# no pppoe intermediate-agent
Related Commands Command
pppoe intermediate-agent
format-type (interface)
pppoe intermediate-agent
limit rate
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-524
pppoe intermediate-agent
no pppoe intermediate-agent
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Sets circuit ID or remote ID for an interface.
Limits the rate of the PPPoE Discovery packets coming on an
interface.
OL-25342 -01