AMX Rack Rail Kit MMS Servers Installation Manual page 2

Mms servers - rack rail kit

Step Five: Load the MMS Server Into the Rack

Once the Outer Rail/Bracket assemblies have been installed in the rack

cabinet, the MMS server can slide into the rack, using the Inner Server

Rails (already attached to the server chassis):

Carefully align the front of the Outer Slide Rails (in the rack) with the

Inner Server Rails (on the MMS server chassis).

Slowly slide the MMS server, into the outer slide rails. Keep the MMS

parallel to the floor when sliding the server rails into the slide rails.

Tilting the server up or down could result in damage to the slide rail

assembly.

Push the locking tabs in to lock into place. The MMS server slides

into the rack until the Locking Release Tabs on the Inner Server Rails

engage the Outer Slide Rails.

Note: Be careful when pressing the Inner Server Rail release latches and

sliding the server into the rack. The slide rails could pinch your fingertips.

Rack (front)

FIG. 4

Sliding the MMS server chassis into the rack

AMX Corporation reserves the right to alter specifications without notice at any time.

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com

Inner Server Rail

Outer Slide Rail

Extension Bracket

REV: B

93-2178-13