Manual Image Setup
If the monitor is in sleep
mode, it might automatically
turn off while you are waiting for it
to warm up.
14
Normally, you can complete the setup procedure using
however, if your screen image is still distorted after you perform
(
) or the User's Guide and Installation CD does not run on your system,
perform
M
S
ANUAL
ETUP
1.
Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2.
Display the image you most frequently use on the screen.
3.
Press the OSD Enter button
initial OSD menu.
4.
Use the
button to select the Image Setup icon (
OSD Enter button
5.
Use the
button to select Manual. Press Enter and Clock becomes
highlighted. Press Enter again and adjust the screen quality settings.
Press Enter twice to select Phase, the right arrow icon, and then Enter
again to select phase. Adjust Phase, then press Enter twice to save
and exitsub-menu.
6.
Press the Exit (
You have completed monitor setup.
.
at the bottom of the bezel to display the
to access.
) button to exit Image Setup.
(
);
I
S
MAGE
ETUP
I
S
MAGE
ETUP
) and press the