6. Factory charge is shown on unit rating plate. Adjust charge by
following procedure shown on charging tables located on unit.
SEQUENCE OF OPERATION
Turn on power to indoor and outdoor units. Transformer is
energized.
On a call for cooling, the thermostat makes circuits R-Y and R-G.
Circuit R-Y energizes contactor, starting outdoor fan motor and
compressor circuit. R-G energizes indoor unit blower relay,
starting indoor blower motor on high speed.
When thermostat is satisfied, its contacts open, de-energizing
outdoor contactor and indoor blower relay. Compressor and
motors stop.
If indoor unit is equipped with a time-delay relay circuit, indoor
blower will run an additional 90 seconds to increase system
efficiency.
CARE AND MAINTENANCE
For continued high performance and to minimize possible equip-
ment failure, periodic maintenance must be performed on this
equipment.
Leave User's Manual with homeowner. Explain system operation
and periodic maintenance requirements outlined in manual. Fre-
quency of maintenance may vary depending on geographic areas,
such as coastal applications which require more frequent mainte-
nance.
4