Kenwood KTC-SRSOI Instruction Manual page 3

1 AWARNING 1
l-3mE-l
To prevent injury and/or fire, take the
following precautions:
l
When extending the battery, or ground wires.
make sure to use automotlve-grade wires or
other wires with a 0.75mnY (AWGI 8) or more
to prevent wire detenoratlon and damage to
the wire coating.
l
Insert the unit all the way until It IS fully locked
In place. Otherwise It may fly out of place
during colllslons and other jolts.
l
To prevent short clrcults, never put or leave any
metallic objects (e.g., coins or metal tools)
InsIde the unit.
l
If the unit starts to emit smoke or strange
smells, turn off the power lmmedlately and
consult your Kenwood dealer.
l
Be careful not to drop the unit or subject tt to
strong shock.
1 ACAUTION 1
To prevent damage to the machine,
take the following precautions:
l
Make sure to ground the unit to a negative 12V
DC power supply.
l
Do not open the top or bottom covers of the
unit.
l
Do not Install the unit In a spot exposed to
direct sunllght or excessive heat or humldlty.
Also avoid places with too much dust or the
posslblllty of water splashing.
l
When replacing a fuse, only use a new one
wtt# the prescribed rating. Using a fuse with
the wrong rating may cause your unit to
malfunction.
l
During Installation, do not use any screws
ewept for the ones provided. The use of
Improper screws might result In damage to the
main unit.
l
When drllllng a hole In the car to fix the
brackets, make sure not to damage the fuel
tank, brake tube, wlnng harnesses, etc. on the
other side.
l
If you experience problems during Installation,
consult your Kenwood dealer.
l
If the unit does not seem to be working right,
try pressing the reset button on the control unit
first. If that does not solve the problem, consult
your Kenwood dealer.
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modlflcatlons to
this equipment may cause harmful interference
unless the modlflcatlons are expressly
approved In the instruction manual. The user
could lose the authority to operate this
equipment if an unauthorized change or
modlflcatlon
IS
made.
Cleaning the Unit
If the front panel
IS
dirty, wipe It clean with a
sIllcon cloth or soft dry cloth with the power
off.
1 ACAUTION 1
Do not use hard cloths or paint thtnner, alcohol,
or other volatile solvents. These may damage
external surfaces or remove Indicator
characters.
IMPORTANT INFORMATION
About the disc changer to be
connected:
To connect a disc changer having the "O-N"
switch to this unit, set the "O-N" switch to "N"
To connect a disc changer having no "O-N"
switch to this unit, the converter cord CA-
DSI 00 and/or switching adapter KCA-S21 OA
are required as options.
English- 3