JBL LSR4328P Owner's Manual page 11

+4dBV (switch IN) or -10dBu (switch OUT) to match the nominal level of the
signal source. If you don't know how to set the switch, consult the documentation
for the signal source. Most professional devices operate at +4dBV while most
consumer devices operate at -10dBu. (See page 23 in this manual for audio con-
nections and wiring diagram.)
Do NOT make connections to both the XLR and ¼ analog connectors; use one or
the other.
b. If you are connecting digital signals (i.e., from a digital console or workstation,
or from the digital outputs of a CD or DVD player or processor), use appropriate
cabling to make a connection between the device and the rear panel AES/EBU
(XLR) or S/PDIF (phono) input of the speaker designated to carry the LEFT
channel (i.e., the left speaker in a stereo setup). Then use appropriate cabling to
make a connection between the rear panel AES/EBU (XLR) or S/PDIF (phono)
output of the left speaker and the rear panel AES/EBU or S/PDIF input of the
speaker designated to carry the RIGHT channel (i.e., the right speaker in a stereo
setup). (See page 24 in this manual for a wiring diagram.)
When using digital audio inputs, the rear panel DIP switch settings determine which
channel of the stereo AES/EBU or S/PDIF signal will be reproduced by each speaker.
7. Press the front panel INPUT button on any speaker so that it begins blinking. While it is
still blinking, press the + / - controls on any speaker to select the desired input. The front
panel LEDs and the rear panel ACTIVE INPUT display shows which of the three inputs
(Analog, S/PDIF, or AES/EBU) is currently selected. If a digital input is selected, the rear
panel ACTIVE INPUT display also shows which channel is being reproduced by
that speaker.
LSR4300 Front Panel
Quick Start
7