Auto Setup For Windows 3.1, Windows 95, Windows 98, Windows Nt Or Windows 2000 - IBM 31P6259 User Manual

15-inch tft lcd monitor
Table of Contents

Advertisement

T50_setup.fm Page 10 Thursday, August 9, 2001 11:09 AM
Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT
or Windows 2000
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
The size and diversity of
the dot pattern varies with
the screen resolution.
Position the mouse pointer
at the bottom center of the
A
screen. This allows
UTO
S
to run properly
ETUP
10
1.
Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
that the video interface cable is connected properly.
the correct video adapter card is installed.
the correct supported display mode is selected for your PC.
2.
Wait approximately 15 minutes, until the monitor warms up.
3.
Drag the icon bar and tool bar, if they are displayed, to the bottom of the
screen.
4.
Insert the diskette labelled 'IBM Flat Panel Monitor Installation Disk' into
the diskette drive.
5.
Check the operating system installed on your PC and follow the
instructions from the table below.
Operating
Step1
System
Windows 3.1
Open
P
ROGRAM
Windows NT 3.5
M
ANGER
Windows 95
Select
Windows 98
S
TART
Windows NT 4.0
6.
When the test pattern appears, press the OSD Menu button
bottom of the monitor to display the initial OSD menu.
- , +
7.
Use buttons (
) to select the
OSD Menu button
- , +
8.
Using buttons (
button
. This activates the
the display settings with the provided test pattern.
The screen will dim, blink on and off several times, and you may notice
small changes to the test pattern.
To abort the
A
S
UTO
ETUP
9.
When finished, the OSD main menu returns. Press the Exit button once
to exit from the OSD.
10. Press the
key to return to Windows.
E
SC
Step2
Step3
Select
Select
F
R
ILE
Select R
UN
icon
IMAGE LOCK
to access the function.
), select
and press the OSD Menu
AUTOMATIC
procedure, which will optimize
A
S
UTO
ETUP
function, press the
E
SC
Step4
UN
Type
'A:\TESTPAT'
and press
ENTER
at the
and press the
key.

Advertisement

Table of Contents
loading

This manual is also suitable for:

31p626095119511-agc9511-awcT509511-axc series

Table of Contents