T50_setup.fm Page 12 Thursday, August 9, 2001 11:09 AM
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
12
Normally, you can complete the setup procedure using
if your screen image is still distorted after you perform
setup diskette does not run on your system, perform
1.
Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2.
Display the image you most frequently use on the screen.
3.
Press the OSD Menu button
the initial OSD menu.
- , +
4.
Use buttons (
) to select the IMAGE LOCK icon
OSD Menu button
- , +
5.
Using buttons (
), select
once to select
COARSE
illuminated
.
- , +
6.
Use the buttons (
possible) for noise in the video signal then press Exit to save the
changes.
- , +
7.
Use buttons (
) to select
- , +
8.
Use the buttons (
9.
When finished, press the Exit button four times to exit from the OSD.
You have completed the monitor setup.
Manual Setup
M
at the bottom of the monitor to display
to access the function.
, press
MANUAL
. Left and right adjustment indicators become
) to manually adjust to correct (as much as
and press the
FINE
) again to tune the image to your liking.
, however,
A
S
UTO
ETUP
or the
A
S
UTO
ETUP
.
S
ANUAL
ETUP
and press the
+
and then press "
"
button.