Charging The Battery; Switching On The Smartphone - Nokia 7710 User Manual

ReMX_UG.book Page 16 Tuesday, March 1, 2005 11:15 AM
To remove the memory card, remove the back cover
with the back of the smartphone facing you, by
pressing the back cover release button and lifting off
the back cover (See fig. 4). Remove the memory card by
gently pulling it out of the slot. Be careful not to
scratch the golden contacts of the card.
To install the memory card, remove the back cover
with the back of the smartphone facing you, by
pressing the back cover release button and lifting off
the back cover (See fig. 4). Gently push the memory
card into place (See fig. 7). Make sure that the gold
contacts of the card are facing down.
Note: Use only compatible MultiMedia Cards (MMC)
with this device. Other memory cards, such as Secure
Digital (SD) cards, do not fit in the MMC card slot and
are not compatible with this device. Using an
incompatible memory card may damage the memory
card as well as the device, and data stored on the
incompatible card may be corrupted.

Charging the battery

While charging, do not use features such as Web browser
or RealOne player, which consume a lot of power. Too
many power-consuming activities may prevent the battery
from charging properly.
1
Connect the charger connector to the base of the
smartphone (See fig.2 on page 13).
16
2
Connect the charger to a wall outlet. The battery
indicator bar starts scrolling in the status indicator
area. The smartphone can be used while charging. If
the battery is completely discharged, it may take up to
a few minutes before the charging indicator is shown.
3
When the battery is fully charged, the bar stops
scrolling. Disconnect the charger from the smartphone,
then from the outlet.
See also "Battery information" on page 146 and
"Enhancements, batteries, and chargers" on page 11.

Switching on the smartphone

WARNING: To use any features in this device, other
than active alarms, the device must be switched on.
Do not switch the device on when wireless phone use
may cause interference or danger.
To switch the smartphone on or off, press and hold
the power key . This smartphone can be used
without the phone functions when the Flight profile is
selected. For more information, see "Profiles" on page
44.
If the smartphone requests a PIN code, enter the
code (displayed as ****), and tap OK. The PIN code
protects your SIM card against unauthorised use and is
usually supplied with the SIM card. After three
consecutive incorrect PIN code entries, the PIN code is
blocked, and you must unblock it with a PUK code