Error Code Message And Solution Operation - Sym ATTILA RS-21 EFi 150 Service Manual

Error Code Message and Solution Operation

DTC Solution Flash
Code Priority code
P0217 1
P0335 2
P1120 2
P1121 2
P1122 2
P0560 1
P0110 2
P0410 2
This chapter Contents
Message
1. Stopping the motorcycle immediately, and solve it
2. Check if the lubricant system for abnormal?
Engine
3. Is the ignition or fuel supply system in normal?
1
temperature
4. Has the engine shown burnt?
overheat
5. Make sure if the engine temperature senor is in
6. Make sure if the connector is in normal.
1. Check if the connection of the crank position sensor
2. Check if the air gap between the sensor and gear
Crank position
2
sensor
3. Check if the crank rotation is run-out.
4. Check if the sensor is in normal according to the
1. Connect the disgnosisor and reset the throttle valve
2. Make sure if the wire circuit of the throttle valve
Poor contact of
3. Check if the openness of idle speed by-pass valve
3
the throttle
valve sensor
4. Adjust the idle speed CO value to specified range.
5. If this problem symptom still existing, check if the
1. Make sure if the wire circuit of the throttle valve
Application
malfunction of
4
2. If this problem symptom still existing, check if the
the throttle
position sensor
1. Make sure if the wire circuit of the throttle valve
Rotation speed
malfunction of
5
2. If this problem symptom still existing, check if the
the throttle
position sensor
1. Make sure if the battery voltage is too low or high
2. Make sure if the ACG generator charging system
Abnormal
6
battery voltage
3. Make sure if the 15
warning
4. Make sure if the battery is in normal. Replace it with
1. Make sure if the sensor's resistor is in normal (20¢ J
Abnormal
intake 2. Make sure if the sensor's wire is in open-circuit (the
7
temperature
sensor 3. Make sure if the sensor is normal according to the
1. Make sure if the sensor's resistor is open or short
Abnormal air 2. Make sure if the sensor's wire is in open-circuit (the
8
by-pass valve
3. Make sure if the by-pass valve is normal according
4. FUEL INJECTION SYSTEM
Solution Operation
with priority
normal.
is open-circuit.
tooth is within specification.
new component replacement procedure.
position. Make sure if the idle speed position is
within specified range.
position sensor is loosen or short.
is within specification. (40~100%)
(0.5%~2.0%)
throttle position sensor (TPS) is in normal according
to the new component replacement procedure.
position sensor is loosen or short.
throttle position sensor (TPS) is in normal according
to the new component replacement procedure.
position sensor is loosen or short.
throttle position sensor (TPS) is in normal according
to the new component replacement procedure.
(below 10V or exceed 16V)
circuit is short or abnormal.
th
terminal on the ECU to battery
positive post is short.
new if the battery is out or order.
2353~2544Ω).
22th terminal on ECU).
new component replacement procedure.
circuit.
13th terminal on ECU)
to the new component replacement procedure.
4-21