Pearl DLC-C003 Operator's Manual page 61

• The Preset Faders control individual dimmer channels and fixture
intensities. The 2 buttons below the faders select and flash
fixtures. Each fader and buttons is called a "Handle".
• The Mode select keyswitch sets the operating mode of the
console; Program for programming a show, Run for running the
show and System for configuring the console.
• The Page select roller lets you select different pages of
playbacks, and you can write the playback names on the roller so
you know what's in them.
• The Master faders control the overall output of the various parts
of the console. You will normally have these set at Full.
• The Playback faders and flash buttons are used to play back
memories you have programmed, when you are running a show.
• The Main display is the nerve centre of the console and shows
you what is going on. The display can show various screens of
information.
• The Control wheels are used to set control values on the fixtures,
and to set chase speeds and fades.
• The Menu softkeys (labelled A – G) are used to select control
options. The display next to the buttons shows what each one will
do. The options for each key change depending on what the
console is doing. Softkey commands are shown in the manual with
square brackets like this: A [Chase Parameters]
• The Numeric keypad and other control buttons are used to enter
values and change controls on the console.
• The Fixture Page buttons are below the keypad, which select 4
pages for the Preset Faders.
• The blue Command buttons are used to carry out functions such
Page 61 of 163