Displaying The Cue Timings - Pearl DLC-C003 Operator's Manual

cue starts to fade out
C [Fade In] - Time to fade in
D [Fade Out] - Time to fade out
E [LTP Fade] - Time for the LTP (movement) channels to fade over
F [LTP Wait] - Delay before the LTP channels start to move
• Links are set to OFF by default, so that you press the Go button
for each cue. If you set links to On for a cue, the next cue will run
automatically after the "Wait Out" time.
• You can enter minutes as part of the time - press the decimal
point twice, a colon (:) will appear. e.g. to enter 20 mins 10.5
seconds, type 20..10.5 (the display will show 20:10.5).
8.2.2

Displaying the cue timings

Press View then Connect to display the cue
timings on the LCD screen. When you are in
theatre mode, the cue timings are
permanently displayed on the VDU screen.
The list of cues automatically moves so that
the current step is at the top.
For each step, the first line shows the step
number, whether links are off or on for that
step (Off="-", On=down arrow), and whether
the step is Simple (S) or Complex (C)
(theatre stack steps are always Complex.)
The second line shows the Wait In, Wait Out
and LTP Wait times for the step.
The third line shows the Fade In, Fade Out and LTP fade times for the
step.
Page 113 of 163