Troubleshooting Guide - PowerWasher PW2623C Instruction Manual

• Merchandise sold by POWERWASHER
identified as the product of another company, such as gasoline engines. The
product manufacturer's warranty, if any, will apply.
• ANY INCIDENTAL, INDIRECT OR CONSEqUENTIAL LOSS, DAMAGE,
OR ExpENSE ThAT MAY RESULT fROM ANY DEfECT, fAILURE OR
MALfUNCTION Of ThE pRODUCT IS NOT COVERED bY ThIS WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
IMpLIED WARRANTIES, INCLUDING ThOSE Of MERChANTAbILITY OR
•
fITNESS fOR A pARTICULAR pURpOSE, ARE LIMITED TO ONE YEAR fROM
ThE DATE Of ORIGINAL pURChASE. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitations may not apply to you.
OpERATIONAL
ISSUE
Engine will not
start (see Engine
Manual for
further engine
troubleshooting)
No or low
pressure
(initial use)
TrOUbLE SHOOTING GUIDE
pOSSIbLE CAUSE
No fuel.
Pressure builds up after
two pulls on the recoil
starter or after initial use.
Choke lever in the "No
Choke" position.
Spark plug wire not attached. Attach spark plug wire.
Engine switch in OFF
po si tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time.
Spray wand not in
high pressure.
Low water supply.
Leak at high pressure
hose fitting.
Nozzle obstructed.
Water filter screen clogged.
Air in hose.
which has been manufactured by and
®
SOLUTION
Add Fuel.
Squeeze gun trigger to relieve
pres sure.
Move choke to the "Choke"
po si tion.
Place engine switch
in ON position.
Move choke to the "No Choke"
po si tion.
See how to Use Spray
Wand instructions in the
Operation Section.
Water supply must be at
least 5 gpm @ 20 psi.
Repair leak. Apply sealant tape
if necessary.
See Nozzle Cleaning
instructions in the
Maintenance section.
Remove and clean filter.
Turn off the engine, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Re- con nect
water source to pump inlet and
turn on wa ter source. Squeeze
trigger to re move re main ing air
19 - ENG