Avital 4103 Installation Manual page 33

to the LED ON settings. These are called the default settings. Pressing
will set it to the LED ON setting. Pressing
cycle through the available options in each feature.
You can advance from feature to feature by pressing and releasing the
Program switch the number of times necessary to get from the feature
you just programmed to the feature you wish to access. For example,
in Menu One, if you just programmed feature 1-3 to off, and you next
want to program the next feature 1- 4, release the Program switch.
Press and release it once to advance from Feature 1-3 to Feature 1- 4.
Then press it once more and
to confirm that you have accessed Feature 1- 4.
The learn routine will be exited if any of the following occurs:
• The ignition is turned on.
• The Program switch is pressed too many times.
• More than 25 seconds elapses between programming steps.
© 2008 Directed Electronics. All rights reserved.
Release.
5. The Program switch can now be re-
leased.
HOLD
DRW-226
it. The LED will flash in groups of 4
on the remote will
33