REGISTRATION FAILED appears on the
handset.
The answering system does not record
messages.
The answering system does not
respond to remote commands.
79
•
Only one handset can be registered at a time. If you have multiple handsets to register, please
follow the instructions on page 58 for the first handset. Once a handset has been successfully
registered, repeat the steps for each handset that needs to be registered.
•
Make sure that the telephone base and handset(s) are in idle mode when registering a
handset.
•
Follow the steps on page 80 for the common cure for electronic equipment, then try again to
register a handset.
•
Make sure the answering system is on.
•
When the answering machine memory is full, it does not record new messages until some old
messages are deleted.
•
If there is a fax machine connected to the same telephone line, try disconnecting the fax
machine. It that solves the problem, consult your fax machine documentation for information
on compatibility with answering systems.
•
Make sure your remote access code is correct.
•
Make sure you are calling from a touch-tone telephone. When dialing a number, there should
be tones. If there are clicks, then it is not a touch-tone telephone and cannot activate the
answering system.
•
The answering system may not detect the remote access code when your announcement is
playing. Wait until the announcement is over before entering the code.
•
There may be interference on the telephone line you are using. Press the dial pad keys firmly
when dialing.