VTech LS6245 Quick Start Manual

Quick start guide
for model LS6245
Install the telephone base
Install the telephone base as shown below.
Electrical outlet
Telephone wall jack
not controlled
by a wall switch
Telephone
base power
adapter
DSL filter (not
included) is
required if you
have DSL high
speed Internet
service
Telephone line cord
Telephone base
1. Use only the power adapter and battery supplied
with your VTech telephone.
2. For complete feature instructions, please refer to
your user's manual.
Battery installation and charging
Install the battery as shown below. For optimal
performance, charge the handset battery for at least 16
hours before use.
1. If the battery 2. Plug the battery
compartment cover connector securely
is on the handset, into the socket
press on the triangle inside the handset
and slide the cover to battery compartment,
remove. matching the color-
coded label.
3. Place the battery with 4. Align the cover flat
the label THIS SIDE against the battery
UP facing up and the compartment, then
wires inside the battery slide it towards the
compartment. center of the handset
until it clicks into place.
5. Charge the handset
by placing it in the
telephone base. The
CHARGE light is on
when the handset
charges.
CHARGE light
Pair your first Bluetooth cell phone
To pair and connect your first Bluetooth cell phone:
1. Press the MENU softkey on the
telephone base.
BASe
2. Press / VOL + or VOL - / to
highlight Bluetooth, then press 2:22pm
redIAl
the SELECT softkey.
/ /
3. Press VOL + or VOL - to
Page al l HS
highlight Setup cell, then press
Intercom
the SELECT softkey.
Bluetooth
Press the NEXT softkey to
4.
set the telephone base in
discoverable mode.
Setup cel l
5. Turn on the Bluetooth feature of
Setup headset
your cell phone and search for
Active devices
or add new devices.
6. Once your cell phone finds
VTech LS6245, select it.
Pls set your
cel l to search
7. Enter the telephone base PIN
for devices
(the default PIN is 0000) into
your cell phone.
8. When successfully connected,
Device connected to base
lS6245
displays.
discoverable
PIn:0000
The pairing process may take
up to one minute. If the pairing
process fails, try again.
Pairing
complete
device
connected
to base
Pair your first Bluetooth headset
To pair and connect your first Bluetooth headset:
1. Press the MENU softkey on the
telephone base.
2. Press / VOL + or VOL - / to
12/25 highlight Bluetooth, then press
menu
the SELECT softkey.
/ /
3. Press VOL + or VOL - to
highlight Setup headset, then
press the SELECT softkey.
4. Set your headset to
Select
discoverable mode.
5. Press the NEXT softkey on the
telephone base to search for
your headset.
Select
6. Once the telephone base
finds your headset, press the
SELECT softkey.
7. Enter the PIN of your headset
(the PIN for most Bluetooth
devices is 0000), then press
next
the NEXT softkey. The screen
displays Headset setup
complete.
8. When the base displays
Connect headset to base?,
press the YES softkey.
9. When successfully connected,
Device connected to base
displays.
The pairing process may take
up to one minute. If the pairing
process fails, try again.
BASe
2:22pm 12/25
redIAl menu
Page al l HS
Intercom
Bluetooth
Select
Setup cel l
Setup headset
Active devices
Select
Pls set headset
to discoverable
mode
next
Searching
for headset
Select HeAdSet
mary's Headset
Select
enter PIn
----
next
Headset setup
complete
connect headset
to base?
yeS no
device
connected
to base