Directed Electronics 474A Owner's Manual page 9

• Once the vehicle has started, it will run for the pre- pro gram med
period of time (12, 24, or 60 minutes) or until a shutdown input
is trig gered.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn it to the ON (not the START)
po sition.
2. Press the brake pedal. The remote start system shuts down and the
engine continues to run because the ignition has been turned on.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the system
monitors the ve hi cle and automatically shuts down the engine if it receives
any of the following shut-down inputs:
Category
• The brake pedal is pressed.
Control
• The hood is opened.
• The shutdown toggle switch is put into the OFF position.
• The pre-programmed run time (12, 24, or 60 minutes) has elapsed.
Toggles
Scan mode
• Remote control button
© 2010 Directed Electronics. All rights reserved.
Warning!
It is unsafe to operate a vehicle's motor in a
garage or other closed off area. Breathing the ex haust
from the vehicle is hazardous to your health. Never
activate the remote start in an enclosed space.
Bank and
present
indicator
AUX
AUX
REW
1
Tune mode
indicator
11:53
CATEGORY CH
XM1-1 CH-001
AUX
FF PLAY/PROG
2 3
is pressed once.
SCAN
VOL
AUDIO
PWR
Channel
and text
indicator
NR DISC- DISC+
4 5 6
Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Rep
SOUND
7