Toshiba Carrier MMU-AP0182H2UL Service Manual page 135

No. Part name
Electric parts 1) Perform work of item
assembly
2) Take off PMV cover fixing screws (2 pcs.)
3) Take off drain guide fixing screws (2 pcs.)
4) Take off earth screw (1 pc.) fixed to the
5) Pull out TC1, TC2 and TCJ sensors from
6) Take off the connector cover mounting
7) Take off the clamp base mounting screw
8) Remove the bundling band and then
9) Disengage the display unit by simply
10) Remove the fixing screw that secures
Same as reassembly pace Addition of the
following cautions
<Cautions in reassembling>
Mount the electric parts box to the main unit
in the reverse order to the removing procedure.
Determine the sensor positions and lead
wire drawing as same as those before
removing according to the figure.
Procedures
and then remove PMV cover.
and then remove the drain guide.
end plate.
the sensor holder of the heat exchanger.
(When reassembling the electric parts, be
careful to the attaching positions of every
sensor. TC2 and TCJ sensors resemble in
the shapes, so distinct them by marking,
etc. when mounting them.)
screw (1 pc.) and then remove the
connector cover.
(1 pc.) and then remove the clamp base.
remove the fan motor connector (5P), the
connector (5P) for louver motor and the
connector (6P) for PMV motor from the
P.C. board.
(When mounting the P.C. board, fix the
lead wires again by the bundling band.)
Tighten the bundling band at the same
position before removing.)
pushing at the top of the display unit.
the electric parts box assembly, LED
assembly and remove the assembly.
.
Drain guide
Drain guide Drain guide Drain guide
fixing screw fixing screw fixing screw
Earth screw Earth screw Earth screw
Connector cover Connector cover Connector cover
TC2 sensor TC2 sensor
TC2 sensor
(0.24"(6mm)) (0.24"(6mm))
(0.24"(6mm))
Clamp base Clamp base Clamp base
Fan motor connector Fan motor connector Fan motor connector
PMV connector PMV connector PMV connector
Binding band Binding band Binding band
135
PMV cover
Remarks
PMV cover fixing screw PMV cover fixing screw PMV cover fixing screw
Connector co
fixing screw
TCJ sensor
(0.24"(6mm) sleeve provide
TC1 sensor (0.16"(4mm)
TC1 sensor (0.16"(4mm)) TC1 sensor (0.16"(4mm)
Fixing sc Fixing screw Fixing sc