Toshiba Carrier MMU-AP0182H2UL Service Manual page 115

No. Part name
3 1. Detachment
Adjust
corner cover
1) Perform work of procedure of 1 -1.
2) Turn clockwise screws (4 positions) at the
NOTE)
When you work, keep the torque at below
8.9ft . lbs12Nm.
Do not use an electric screwdriver; otherwise the
mechanism of adjust corner cover may be
damaged and not be removed.
3) Pull downward the risen-up part of adjust
4) Remove the strap of adjust corner cover.
2. Attachment
1) Attach the strap of adjust corner cover to
2) Turn screws (4 positions) of the suction
NOTE)
When you work, keep the torque at below 8.9ft . lbs12Nm.
Do not use an electric screwdriver;
otherwise the mechanism of adjust corner cover
may be damaged and not be removed.
1. Detachment
4 Ceiling
panel
1) Perform works of procedure 2 -1, and 3 -1.
2) Remove the flap connector (CN33, White,
NOTE)
Remove the connectors after unlocking the lock
of the housing.
3) Take off screws (M5, 4 pcs.) fixing the
4) Push the temporary bracket to inner side to
2. Attachment
1) Hook the panel to the temporary bracket of
NOTE)
The panel has directionality. Therefore mount the
panel according to the temporary bracket and the
bracket mounting position.
2) Tighten the fixing screws. (M5, 4 pcs.)
3) Connect flap connector of the ceiling
Procedure
suction port corner until adjust corner
cover rises up.
corner cover and remove it.
the panel, hook claws of adjust corner
cover to the panel corner, and then push
the opposite side into the panel.
port corner counterclockwise until bump
between adjust corner cover and panel
disappears.
5P) connected to the control P.C. board
and then take off the lead wire from the
clamp.
ceiling panel.
remove the ceiling panel.
the drain pan of the main body.
panel to the connector
(CN33, White, 5P) of the control
P.C. board.
115
Remarks