Table of Contents
Advertisement
Registration
Code
Registering the
Handset to the
DECT System
Selecting the
DECT System
46
D i t d o c u me n t wo r d t u a a n g e b o d e n d o o r T e l e c o mH u n t e r . D é z a k e l i j k e T e l e c o m we b s h o p .
T 0 8 8 7 4 6 3 4 4 4 | @ s a l e s @T e l e c o mH u n t e r . n l | www. T e l e c o mH u n t e r . n l
21 Menu: System
The handset can be operated with a maximum of 10 DECT
systems. Before you can make a call via the DECT system, the
handset has to be registered to the respective system. A system
ID and registration code may be necessary for the registration
process. Ask the respective system administrator for the valid
registration code. When the handset is not yet subscribed to
the system the display is showing No Subscription.
All settings in this chapter are started by pressing the softkeys:
F
Menu
System OK
Then select ...
F
Subscriptions OK Options
Z
display with OK)
PARK OK
Z
Z
system name OK
The following entries must be made when logging on:
Enter PARK: a system ID should only be entered if you are at a
location where two DECT systems overlap. If only one DECT
system is available, then just press OK.
Enter Auth.Code: this code is used to register the handset
(authentication code). The DECT system supplies this code.
Enter Name: give the name of the DECT system to which you
are registering. This will be shown on the idle display. For in-
formation concerning the entry of characters, refer to Entering
Characters / Names starting on page 33.
Enter Number: the phone number, assigned to your DECT
handset can be entered here (ask your system administrator for
the phone number).
Press Esc twice to return to idle mode.
F
Subscriptions OK
If the handset has been registered to several DECT systems,
then you can select which one the handset is to use. Select the
F
New (confirm the IPEI
Z
PIN (authentication code) OK
local phone number OK
F
select a system Options Select OK
Advertisement
Table of Contents
