Care And Maintenance - Pride Celebrity X-6 Owner's Manual

X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorised Pride
Dealer. The following areas require periodic inspection and/or care and maintenance.
TYRE PRESSURE
If equipped with pneumatic tyres, always maintain a proper 2-2.4 bar (30-35 psi) tyre pressure.
WARNING! It is important that 2-2.4 bar (30-35 psi) tyre pressure be maintained in pneumatic
tyres at all times. Do not underinflate or overinflate your tyres. Low pressure may result in
loss of control and overinflated tyres may burst. Failure to maintain 2-2.4 bar (30-35 psi)
tyre pressure in pneumatic tyres at all times may result in tyre and/or wheel failure, causing
serious personal injury and/or damage to your scooter.
Regularly inspect your scooter's tyres for signs of wear.
WHEEL REPLACEMENT
If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced. If your
scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be replaced depending on
model. Contact your authorised Pride Dealer for information regarding replacement wheels for your scooter.
WARNING! Prevent personal injury! Completely deflate pneumatic tyres before dismantling
the rim or attempting repair.
WARNING! When changing a tyre, remove only the centre lug nut, then remove the tyre. If
any further disassembly is required, deflate the tyre completely or it may explode, possibly
resulting in personal injury.
EXTERIOR SURFACES
Bumpers, tyres, and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat, floorboard
or tyre tread. They will become dangerously slippery and result in personal injury and/or
damage to your scooter.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Prevent personal injury and product damage! Follow all safety instructions for
the proper use of the disinfectant before applying it to your product.
ABS PLASTIC SHROUDS
The shrouds of the scooter are formed from durable ABS plastic and are coated with an advanced formula
urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
Celebrity X-6 www.pridemobility.com
37