D-Link DFE-650 Series User Manual page 34

DFE-650 Series Fast Ethernet PC Card User's Guide
ODI Driver Selection Screen
Disregard the "Board" textbox at the top of this dialog box. In the
"Driver" section below the textbox, select the 32 bit option
button, then choose the Other Boards button. This brings up
the ODI Driver Path dialog box.
The ODI Driver Path dialog box features a textbox for specification
of the full path filename to the ODI driver (Open Data Interface
driver module) needed for operation of the DFE-650 under DOS or
Windows 3.1 OS. That module is supplied on the D-Link DFE-650
Series Fast Ethernet PC Card Driver diskette.
Insert the D-Link DFE-650 Series Fast Ethernet PC Card Driver
diskette into a diskette drive of your notebook PC (here assumed to
be drive A), and type in the textbox to complete the following
entry:
A:\NETWARE\32BITLAN\DFE650.LAN
Then choose the OK button to close the ODI Driver Path dialog
box. In the Select a Board dialog box which then appears, there
will be just one entry: D-Link
DFE-650 Fast Ethernet
. Click that entry to confirm that you are
PC Card Driver
installing the DFE-650, then choose the OK button to close the
Select a Board dialog box.
This returns control to the ODI Driver Selection dialog box. Now
choose the Driver Settings button. The Driver Settings
dialog box appears.
Driver Settings Screen
This screen provides control of four settings. The Connection
setting is an aggregate setting which includes Line Speed
Type
(10Mbps or 100Mbps) and Duplex (Half Duplex or Full Duplex). It
is recommended that you deselect all line speed and duplex
settings, by celecting " none" as Connection Type .
26
Software Installation