D-Link DFE-650 Series User Manual page 18

DFE-650 Series Fast Ethernet PC Card User's Guide
It is most usual for the lower one of the two slots in the
stack to be designated Slot 1, but there are exceptions. In
the
installation, it may be necessary for you to know whether
your DFE-650 is installed in Slot 1 or Slot 2.
Windows 95, you can check by opening the Control Panel /
PC Card display. Under DOS it is also possible to make a
software check, but it is more difficult. If you are unable to
determine the DFE-650's slot number in advance, then you
can make a trial-and-error determination later, according to
instructions given in the Software Installation section of this
chapter.
Step 2 Attach the Media Coupler
The back-end receptacle of the DFE-650 remains accessible
(approximately flush with the case of the computer) when the DFE-
650 is properly seated in its PC Card slot. Taking care to keep the
top side of the media coupler plug up, insert the plug into the DFE-
650's receptacle until it is firmly seated and latched. (The top side
of the plug is labeled with a triangle molded into the plastic.)
NOTE: When the media coupler plug is firmly seated, it is held in
place by small latching hooks at either side of the plug. To
10
subsequent procedure for
Keep the triangle mark on
top when you plug the media
coupler into the DFE-650
DFE-650 software
Hardware Installation
Under