Photo Settings - Sharp ONE User Manual

Photo settings

From the Capture photo screen, tap Settings. The Photo Capture settings screen opens, where you
can manually adjust these settings:
Resolution Choose from:
• Large
• Medium
and uploading.
• Small
Note: The currently-set resolution doesn't display on the capture screen, so if you
temporarily change the resolution for a capture session, be sure to change it back.
Mode Choose from:
• Auto
• Night
• Burst
When you start capture in this mode, the camera will take three successive photos
without flash and preview the last image captured when finished.
Flash Choose from:
• Auto
• Off
Always on
•
Geotags Choose from:
Quick
•
capture it. No overhead is added to the time to take a photo and your battery life
won't be affected significantly.
GPS
•
your photo when you capture it. With this setting, more battery is used.
Lighting
Choose from:
Auto
•
Home
•
Office
•
• Sunny
Cloudy
•
85
- Full-size resolution, largest file size and best quality.
- A compromise between the best and lowest quality. Good for sending
- The smallest file size, but lowest quality. Best for sending and uploading.
- Automatically adjusts exposure based on scene.
- Adjusts the exposure for night lighting.
- Raises the shutter speed, turns off the flash, and enables burst capture.
- Flashes when the camera senses the need.
- Never flashes.
- Always flashes, except in Burst mode.
- The current cellular triangulated location is added to your photo when you
-The current location is determined using the internal GPS and is added to
- Automatically senses the ambient light and adjusts.
- Adjusts to an incandescent light environment.
- Adjusts to a fluorescent light environment.
- Adjusts to a bright light environment.
- Adjusts to muted light environment.
ONE User Guide - R1.0 - April 22, 2010