Wire Connection Guide; Program Jumpers - Viper 500HF Installation Manual

H1/1 ORANGE (-) ground-when-armed output: This wire supplies a (-) 500 mA ground as long as the system is
armed. This output ceases as soon as the system is disarmed. The orange wire is pre-wired to control the 8618
starter kill relay.
NOTE: If connecting the orange wire to control another module, such as a 529T or 530T window con
troller, a 1 amp diode (type 1N4004) will be required. Insert the diode as shown below.
IGNITION SWITCH
IMPORTANT!
interrupt any wire other
than the starter wire.
H1/2 WHITE (+/-) light flash output: As shipped, this wire should be connected to the (+) parking light wire. If the
light flash polarity jumper under the sliding door is moved to the opposite position (see below), this wire supplies a
(-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some Mitsubishi, some
Mazda, etc.
H1/3 WHITE/BLUE channel 3 (-) output: This wire provides a (-) 200 mA signal whenever the transmitter code con-
trolling channel 3 is received. This signal will continue as long as that transmission is received. Use for options such
as the 551T Valet ® Start system, the 529T or 530T power window controllers, etc.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transistorized
output can only provide 200 mA of current, and connecting directly to a solenoid, motor, or other high-cur
rent device will cause it to fail.
© 1998 Directed Electronics, Inc. Vista, CA
9
N438 7/98

WIRE CONNECTION GUIDE

Never
LEARN VALET
LIGHT(-)
LIGHT (+)
TO OPTIONAL SENSORS,
529T, 530T, ETC.