Final Testing; Valet; Mode; Valet ® Mode - Viper 500HF Installation Manual

NPC ™ requires that you change the way you test the system as NPC
If the system "sees" the same zone trigger three times AND the triggers are spaced less than an hour apart,the
system will bypass that input zone for 60 minutes.
If that zone does not attempt to trigger the system during the 60-minute bypass period, the zone's monitoring will
begin again at the end of the hour. NEW! If it does attempt to trigger while bypassed, the 60-minute bypass
starts over again.
Disarming and rearming the system does not reset NPC
pass, without a trigger, or for the ignition to be turned on. This allows the system to be repeatedly triggered, dis-
armed and rearmed, and still allow NPC
NPC is activated. The LED will report the zone that has been bypassed (see diagnostics).
To enter or exit Valet ® Mode with the Valet
Turn the ignition key on then off.
At anytime during the next 10 seconds, press and release the Valet
Now the Status LED will light up constantly if you have entered Valet
and go out if you have exited.
To enter or exit Valet ® Mode with a transmitter:
Open any door.
Press button 1 (or the arm/disarm button).
Press button 2 (or the channel 2 button).
Press button 1 again.
You have now entered or exited Valet
© 1998 Directed Electronics, Inc. Vista, CA
21
N438 7/98

FINAL TESTING

Nuisance Prevention Circuitry
™ . The only way to reset NPC
™ to bypass a faulty zone. When disarming the system, 5 chirps indicate

VALET

MODE

®
® /program switch:
® Mode (verify by checking your Status LED).
TM
™ will bypass an input zone for 60 minutes.
™ is for the 60 minutes to
®
®
switch.
Mode,