Exmark Lazer Z HP Operator's Manual page 20

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.3
4.1.4
4.1.5
4.1.6
4.1.7
By moving both levers an equal amount forward or back from the neutral position
the machine can be caused to move forward or backward in a straight line.
Movement of the left lever forward will cause the left drive wheel to rotate in
a forward direction. Movement of the right lever forward will cause the right
drive wheel to rotate in a forward direction. To stop forward travel, pull the
levers back to the neutral position.
To turn left while moving forward, move the left lever back toward neutral to
slow the left drive wheel. To turn right while moving forward, move the right
lever back toward neutral to slow the right drive wheel.
To make a zero turn to the left, pull the left lever back beyond neutral while
holding the right lever slightly ahead of neutral.
To make a zero turn to the right, pull the right lever back beyond neutral while
holding the left lever slightly ahead of neutral.
Pulling the levers back from the neutral position will cause the respective drive
wheels to rotate in a reverse direction (spring tension can be felt when moving
into reverse from neutral).
To turn to the left while backing, move the left lever forward toward neutral. To
turn to the right while backing, move the right lever forward toward neutral.
POTENTIAL HAZARD
♦ Machine can spin very rapidly by positioning one lever
too much ahead of the other.
WHAT CAN HAPPEN
♦ Operator may lose control of the machine, which may
cause damage to the machine or injury.
HOW TO AVOID THE HAZARD
♦ Use caution when making turns.
♦ Slow the machine down before making sharp turns.
PTO Engagement Switch: Located just left of center on the console (left side of
ignition switch). Switch must be pulled out to the "ROTATE" position to engage
the blades. Switch is pushed in to the "STOP" position to stop the blades.
Choke Control: Located at center of console (right side of ignition switch).
Choke is used to aid in starting a cold engine. The choke control is pulled out
to be in the "ON" position and pushed in to be in the "OFF" position. DO NOT
run a warm engine with choke in the "ON" position.
Throttle Control: Located on console just right of center.
Throttle is used to control engine speed. Moving throttle lever forward will
increase engine speed and moving throttle lever to the rear will decrease
engine speed.
Brake Lever: Located on left side of the console. The brake lever engages a
parking brake on the drive wheels.
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the brake.
The unit must be tied down and brake engaged when transporting.
Ignition Switch: Located on the lower center of console.
www.mymowerparts.com
CAUTION
- 15 -