Arts Polling Time Options; Arts Alert Beep Options; Cw Identifier Setup - Vertex Standard VX-110 Operating Manual

ACENT – Revenda Autorizada VERTEX | Locação | Vendas | Assistência Técnica | Ligue 0800 77-55-200 ou acent@radio-vertex.com.br
ARTS
The ARTS feature may be programmed to poll every 15 seconds (default value) or 25
seconds. The default value provides maximum battery conservation, because the polling
signal is sent out less frequently. To change the polling interval:
Press the [ F ] key, then press the [ M/V ( SET ) ] key, to enter the Set mode.
Rotate the DIAL to select Menu #14 ("
Press the [ F ] key to enable changing of this Menu item.
Rotate the DIAL to select the desired polling interval (15 or 25 seconds).
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
The ARTS feature allows two kinds of alert beeps (with the additional option of turning
them off), so as to alert you to the current status of ARTS operation. Depending on your
location and the potential annoyance associated with frequent beeps, you may choose the
Beep mode which best suits your needs. The choices are:
: The beeps are issued only when the radio first confirms that you are within
: Every time a polling transmission is received from the other station, the alert
: No alert beeps will be heard; you must look at the display to confirm current
To set the ARTS Beep mode, use the following procedure:
Press the [ F ] key, then press the [ M/V ( SET )] key, to enter the Set mode.
Rotate the DIAL to select Menu #13 ("
Press the [ F ] key to enable changing of this Menu item.
Rotate the DIAL to select the desired ARTS Beep mode (see above).
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
The ARTS feature includes a CW identifier. Every ten minutes during ARTS operation, the
radio can be instructed to send "DE (your callsign) K" if this feature is enabled. The
callsign field may contain up to 16 characters.
Here's how to program the CW Identifier:
Press the [ F ] key, then press the [ M/V ( SET ) ] key, to enter the Set mode.
Rotate the DIAL to select Menu #27 ("
VX-110 O
(Automatic Range Transponder System)
ARTS P
ARTS A
range, but does not re-confirm with beeps thereafter.
beeps will be heard.
ARTS status.
CW I
M
PERATING ANUAL
Acesse : www.radio-vertex.com.br
T O
OLLING IME
").
B O
LERT EEP
").
S
DENTIFIER ETUP
").
Operation
PTIONS
PTIONS
27