Switching The Screen Between Full And Zoom (Aspect) - Epson EH-TW5200 User Manual

Adjusting the Image
Mode
3D Dynamic
3D Cinema

Switching the Screen Between Full and Zoom (Aspect)

You can change the input signal's type, aspect ratio, and resolution to match the Aspect of the projection
screen.
The available Aspect varies depending on the image signal currently being projected.
a
Press the button.
c
You can make settings from the
Configuration menu.
Aspect p.47
By normally selecting Auto, the optimum aspect is used to display the input signal. Change the setting if you
want to use a different aspect.
The table below shows the image projected on a 16:9 screen.
Input Image
4:3 Images
16:9 Images
Images Recorded Using
Squeeze
*
Letterbox Images
For use when projecting 3D images. Images are bright and sharper than 3D Cinema.
For use when projecting 3D images.
Signal -
s
Normal
Application
b
Use the
select the setting name, and then
press the
selection.
c
Aspect may not be available
depending on the type of signal.
Setting Name (Aspect)
Full
When projecting 16:9 images, Full and Zoom cannot be
selected.
30
buttons to
button to confirm the
Zoom