Direct Ignition Lighting Instructions - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

DIRECT IGNITION LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. BEFORE LIGHTING smell all around the appliance area
WHAT TO DO IF YOU SMELL GAS
phone.
department.
2. Set the thermostat, if used, to the lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device that
automatically lights the burner. Do not try to light the
burner by hand.
5. Open bottom louver assembly.
6. Turn gas line valve to "ON."
Follow "A" in the safety information above. If you do not
smell gas, go to the next step.
8. Close bottom louver assembly.
2. Turn off all electric power to the appliance.
3. Open bottom louver assembly, or open the valve access
door.
Page 44
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
B. Use only the wall switch or remote control switch to
turn the gas control on/off. Any attempted repairs or
technician. Applying force or attempted repair may result
C. Do not use this appliance if any part has been under
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting (if available).
11. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE," and call your
service technician or gas supplier.
4. Turn gas line valve to "OFF."
5. Close bottom louver assembly, or close valve access
door.
ON
OFF
29354-1-1012