Dvvk-4F Flex Vent Instructions - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

Follow correct option according to venting method.
Connecting Directly to Fireplace
the unit (no rigid venting system is being used), then the gasket
Peel the paper off the self-adhesive gasket and then wrap it around
the end of the tube (if tube was cut, it is recommended to use cut
end) as shown in Figure 51. Pull the gasket tight at all times while
wrapping it around tube. The gasket ends should align, to form a
complete seal. The overlapped section should NOT come in con-
tact with the seam in the tube. Apply high temperature sealant to
the opposite end of the tube (on the inside of the tube). The end
with the gasket will attach to the back of the unit. Continue with
Step 13.
Connecting to Rigid Vent System
venting system (and not directly to the back of the unit), then do
not use the gasket provided. High temperature sealant should be
(if tube was cut, it is recommended to use cut end) and to the in-
side of the tube on the end that connects to the vent cap. Continue
with step 13.
The
pipe)
vent run from top connections, maintain at least ½" rise for
every 12" of vent run. When venting horizontal off the rear
vent connections, allow a minimum rise of 2". Refer to
Figure 44 when mounting termination near vinyl siding.
CAUTION: Always stretch and secure venting with wire or
metal strapping to ensure that the horizontal runs do not
sag.
Page 32
2
1
PARTS LIST
INDEX PART
NUMBER NUMBER
1 DV769
2 19193
3 19194
4 DV524
5 19196
6 20527
If space permits, it is generally easier to attach venting in the
Because of sharp edges, always use gloves when handling
Vent connections should overlap a minimum of 1" for proper
sealing.
Always follow the general venting requirements for vent
materials.
6
4
3
DESCRIPTION
Vent Cap Assembly
Outside Mounting Plate
Air Inlet Tube
Flue Outlet Tube
Firestop/Thimble Assembly
Gasket
29354-1-1012
5