Operating Instructions - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

750 Millivolt System
The standing pilot (750 millivolt system) is a continuous burning pilot.
The pilot remains ON even when the main burner is OFF.
When you ignite the pilot, the thermopile produces millivolts (electrical
current) which energizes the magnet in the gas valve. After 30
seconds to 1 minute time period you can release the gas control
additional one (1) to two (2) minutes before you turn the gas control
knob from the PILOT position to the ON position. This time period
level allowing the gas control to operate properly.
1. Follow the SAFETY and LIGHTING INSTRUCTIONS for
standing pilot controls found in this manual and on labels found
in control compartment behind the door assembly.
least once every second.
2. During the operating season, leave the control valve knob in
OFF/ON switch, wall switch or remote controls.
NOTE: The gas control valve allows you to increase or decrease the
regulator with a knob as shown in Figure 60. Rotate the knob
3. When the operating season is over, turn the REMOTE/OFF/ON
switch to "OFF" and the control valve to "OFF". The system,
including the pilot light, will be shut down.
Page 38

OPERATING INSTRUCTIONS

Figure 60
The OWNER should carefully read and follow these operating
instructions at all times. Lower the door assembly to view the gas
Initial Lighting
Upon completing the gas line or turning the gas valve on after it has
been in the "OFF" position, a small amount of air will be in the lines.
lines to purge themselves of this air. Once the purging is complete,
Subsequent lightings of the appliance will not require such purging
if the gas valve is not turned to "OFF."
Pilot Flame (Figure 61)
The thermopile/thermocouple (standing pilot) tips should be covered
REMOTE/
Figure 61
29354-1-1012