Leica DISTO D330 User Manual page 18

Press this button and trigger the measurement.
D
After the first measurement is recorded and shown
EN
onscreen, the display flashes (2).
F
Triggers the measurement. After the second
measurement is recorded and shown onscreen, the
I
display flashes (3).
E
Press and hold down this button to trigger
continuous measurement. Sweep the laser up and
P
down over the ideal target point.
NL
Press this button to end continuous measure-
DK
ment. The result is displayed in the summary line, the
partial results in the secondary lines.
S
N
Storage of constants/historical
storage
FIN
J
Storage of a constant
CN
You can store and recall a frequently used value e.g.
height of a room. Measure the desired distance,
ROK
press and hold the
PL
to confirm storage.
H
Recalling the constant
RUS
Press this button once to recall the constant
and make it available for further calculations by
CZ
pressing button
Functions
button until the device beeps
.
Adjusting the constant
Press the button for longer to change the constant
- the constant flashes, you can now change the
constant to the required value using the
button. Press the
Historical storage
Press this button twice and the previous 20
results (measurements or calculated results) are
shown in reverse order.
The and buttons can be used for navigation.
Press this button to use a result from the
summary line for further calculations.
Pressing the and
time erases all the values in historical storage.
Timer (self-triggering)
Press this button to set a 5-second time delay.
or
Press and hold down this button until the
desired time delay is reached (max. 60 seconds).
Once the key is released the remaining seconds until
measurement (e.g. 59, 58, 57...) are displayed in a
countdown. The last 5 seconds are counted down
with a beep. After the last beep the measurement is
taken and the value is displayed.
The timer can be used for all measurements.
18
or
button to save the constant.
buttons at the same
Leica DISTO™ D330 776176 en