Leica DISTO D330 User Manual page 12

D
Minimum/maximum measurement
EN This function allows the user to measure the
minimum or maximum distance from a fixed
F
measuring point. It can also be used as to determine
I
spacings.
E
min.
P
NL
DK
S
N
It is commonly used to measure room diagonals
FIN
(maximum values) or horizontal distances (minimum
values).
J
Press and hold down this button until you hear
CN
a beep. Then slowly sweep the laser back and forth
ROK
and up and down over the desired target point - (e.g.
into the corner of a room).
PL
Press to stop continuous measurement. The
H
values for maximum and minimum distances are
RUS shown in the display as well as the last measured
value in the summary line.
CZ
Measuring
max.
12
Laser continuous
Press and hold down the key when switching
on the device until the character
nently in the display and a beep sounds. Every further
press of the key releases a distance measure-
ment.
Press and hold the key to switch the device
and Laser continuous operation off.
If the laser is in continuous operation mode,
the device switches off automatically after 15
minutes.
Leica DISTO™ D330 776176 en
appears perma-