Unlocking The Scanner - AGFA Horizon Ultra Scanner Owner's Manual

3. Remove the plastic wrapping and the packing materials from
the scanner.
4. Fill out the Warranty and Registration form. You will find the
product serial number on the back panel of the scanner.
Note: Do not forget to mail the Warranty and Registration form. Only
then you can claim your guarantee and get the following registration
benefits: new product information, new application software.

Unlocking the scanner

The scanner's optical box contains all optical components and rides
back and forth during the scan. A shipping restraint holds it in place
at the right side of the scanner during shipment. You have to remove
this restraint before powering up the scanner.
1. Remove the panel at the right side of the scanner by loosening
the four screws, as shown in Figure 1-2.
2. Locate the shipping restraint (a screw).
3. Loosen the screw (left), as shown in Figure 1-3, and place it in
the holder next to it (Figure 1-4).
The holder allows you to save the screw so that you can replace it
if you have to move the scanner over long distances.
4. Try to move the optical box to the left. Do not touch the
electronic board, use the lower U-profile instead. If the optical
box is still blocked, unblock it by pushing down the handle that
holds it in place.
5. Bring the panel back in place.
Chapter 1 — Preparing the scanner 14