Installation For The Ibm Ps/2; Which Scsi Adapter Card - AGFA Horizon Ultra Scanner Owner's Manual

4. If the scanner is the last device in the SCSI chain, place the
terminator on the unconnected SCSI port of the scanner.
5. Snap the diamond shaped wire clips into the clip brackets to
secure the connection.
6. Connect the power cable to the scanner.
Make sure that you are using the correct power cable for the
voltage in your area.
7. Switch on the scanner.
The scanner performs a self-test: it produces some sounds and the
indicator lights switch on and off. Then the Busy indicator light
(yellow) switches on, until the self-test is finished. After the self-
test the scanner's Ready indicator light (green) switches on.
8. Switch on your PC.
You are now ready to install and configure Agfa's scanning software.
Please refer to the User's Guide.

Installation for the IBM PS/2

This section shows you how to set up your Horizon Ultra scanner with
your IBM PS/2. You can find information on which SCSI adapter card
to use and instructions for connecting the scanner to your IBM PS/2.
If you have an IBM PS/2 model 30, please refer to 'Installation for the
PC' earlier on in this chapter.

Which SCSI adapter card

The Horizon Ultra scanner requires a SCSI interface card that is
certified to work with your IBM PS/2. If your PS/2 does not have such
a card, contact your dealer or Agfa service representative.
The scanner software supplied with the Horizon Ultra scanner supports
in principle any ASPI-compatible SCSI adapter card. Technical support
however, gives assistance only for the Adaptec line of cards, of which
we particularly recommend the AHA 1640.
Important: Please check the following documentation:
The Read Me file on the PC scanner driver software disk for
up-to-date information.
The documentation supplied with your adapter card. This will
tell you how to install the card.
Chapter 2 — Installing the scanner 30