4. Press the upper part and the bottom plate of the transparency
5. Place the transparency holder in the transparency-holder frame.
6. Place the frame in the top left corner of the glass plate.
Figure 1-11
Placing the frame
with transparency holders
on the scanner
holder together until you hear a click.
Make sure that the pins of the holder are inserted completely in
the holes of the frame (see Figure 1-11). The transparency holder
should be in full contact with the protection foil of the
transparency-holder frame.
Make sure that the slot in the frame (for lamp calibration) is at the
left side. Always cover unused neighbouring holes of the frame
with the round hole covers. This eliminates the visibility of stray
light and reflections.
Chapter 1 — Preparing the scanner
21