Testing The Scanner - AGFA Horizon Ultra Scanner Owner's Manual

7. Leave the document cover open, so that the carriage can move
over the frame.
Note: To remove the transparency holder from the holder frame after
scanning, make sure that the transparency lamp carriage is in its home
position (completely left), and that nobody attempts to start a new scan.

Testing the scanner

You are now ready to perform a power-on test to check if the scanner
is operating correctly.
1. Check whether you have unlocked the scanner.
2. Connect the power cable to the scanner.
Make sure that you are using the correct power cable for the
voltage in your area. Double-check whether the voltage indicated
on the back panel of the scanner corresponds with the voltage in
your area. If not, call your dealer or Agfa service representative.
3. Switch on the scanner.
The scanner performs a self-test after which the Busy indicator
light switches off and the Ready indicator light (green) switches
on. This takes about a minute or more.
If a malfunction is detected during the self-test, that is, if the
Error indicator switches on, refer to Appendix A,
'Troubleshooting'.
Chapter 1 — Preparing the scanner 22